more quick actions
minimize quick actions
Communication interfaces
4
Posts
2
Users
0
Likes
29
Views
Hi guys,
Is anybody outside there, who has experience in configuring Step 7 iso?
Posted : 10/07/2017 7:17 pm
Hi
With S7 1200 / 1500 and with ET200S, the ethernet port is on slot 1. I often see this error during technical support (it was slot 2 with older PLC)
Posted : 10/07/2017 8:16 pm
Hi thanks,
but here the project runs on an s7 300 with cp 343 processor-type.
The main questions are only,
1. whether we are able to map all the variables, they listed. I attached the points.
2. Whether we are able to use SG S7
3. What do we need (driver && software) to communicate to s7 plc and to use the SG S7
We also have the step 7 project.
Posted : 10/07/2017 8:22 pm
1 - I don't see the file you attached
2 - Yes SG S7 create IP ISO S7 communication and you can use it if PLC is uploaded with Step7 (not ok with TiaPortal but Arc is looking for beta site, see Benoit's article)
3- PcVue doesn't need anything (except the Step7 file programm of your PLC)
If possible check that your PLC can communicate with ISO S7 (I am not sure if old S7-300 can communicate with ISO S7)
Posted : 10/07/2017 8:55 pm